Jul 17, 2016 The driver will be recognized as: Cypress FX2LP No EEPROM Device. This driver is probably not going to work with PulseView & we have to install a generic Windows USB driver using Zadig, which is an application that is installed with PulseView. Understand 5.0.960. Cypress' EZ-USB® FX2LP Development Kit (DVK) is a good starting point for developing an EZ-USB based products. The DVK includes everything you will need to get started: a development board, example firmware, a Microsoft certified Signed generic USB device driver (cyusb.sys), documentation, and assorted tools. EZ-USB FX2 Manual Technical Reference. Cypress Disclaimer Agreement The information in this document is subject to. EZ-USB FX2 Technical Reference Manual.
Cypress’s EZ-USB® FX2LP™ (CY7C68013A/14/15/16A) is a low power, highly integrated USB 2.0 microcontroller.
Cypress’s EZ-USB® FX2LP™ (CY7C68013A/14A) is a low power version of the EZ-USB FX2™ (CY7C68013), which is a highly integrated, low power USB 2.0 microcontroller. Find great deals on eBay for cypress ez-usb fx2lp. Shop with confidence.
Smartlf ci scanner windows 10. This chip is a General Programmable Interface (GPIF™) that is supposed to ease the development of USB devices such as keyboards, mouses (mice!), flash drives, etc. Mpc pad 187 for mac os x.
https://yellowbench.weebly.com/dongle-driver-download.html. The board that I ordered is a development board from AliExpress for $4.60 and I was really impressed with its quality.
There are 2 variants, one with one jumper & another with 2 jumpers. Lenovo pci simple communications controller driver. Both comes with a on/off switch and a RESET push button.
The board also has an EEPROM (ATMEL 24C128 on my board) which is used to hold the VID/PID/DID of the device - this is for the host to identify the device to determine the correct driver.
My board was of the 2 jumper model & I think both are the same.
![]()
J1 is to connect/disconnect 2 LEDs from Vcc - these LEDs are connected to D0 & D1
J2 controls the high address bit of the EEPROM making it appear at I2C address 0xA0 or 0xA2 depending on the jumper.
The FX2LP is designed with a unique feature that allows the firmware to be loaded to the chip RAM either from the host or from the EEPROM.
Ez-usb Fx2lp Saleae
Here we will be discussing a very interesting firmware that converts this $4.60 board into a logic analyzer!
Comments are closed.
|
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |